ripng¶

Note

requires a Product License.

RIPng router configuration.

vsr running config# vrf <vrf> routing ripng

aggregate¶

Set aggregate RIPng route announcement.

vsr running config# vrf <vrf> routing ripng
vsr running ripng# aggregate AGGREGATE

AGGREGATE

An IPv6 prefix: address and CIDR mask.

static-route¶

RIPng static routes.

vsr running config# vrf <vrf> routing ripng
vsr running ripng# static-route STATIC-ROUTE

STATIC-ROUTE

An IPv6 prefix: address and CIDR mask.

enabled¶

Enable or disable router.

vsr running config# vrf <vrf> routing ripng
vsr running ripng# enabled true|false

Default value: true

allow-ecmp¶

Allow equal-cost multi-path.

vsr running config# vrf <vrf> routing ripng
vsr running ripng# allow-ecmp true|false

Default value: false

default-information-originate¶

Control distribution of default route.

vsr running config# vrf <vrf> routing ripng
vsr running ripng# default-information-originate true|false

Default value: false

default-metric¶

Default metric of redistributed routes.

vsr running config# vrf <vrf> routing ripng
vsr running ripng# default-metric <uint8>

Default value: 1

network¶

Enable RIP on the specified IP network.

vsr running config# vrf <vrf> routing ripng
vsr running ripng# network NETWORK

NETWORK

An IPv4 or IPv6 prefix: address and CIDR mask.

interface¶

Enable RIP on the specified interface.

vsr running config# vrf <vrf> routing ripng
vsr running ripng# interface INTERFACE

INTERFACE

An interface name.

passive-interface¶

A list of interfaces where the sending of RIP packets is disabled.

vsr running config# vrf <vrf> routing ripng
vsr running ripng# passive-interface PASSIVE-INTERFACE

PASSIVE-INTERFACE

An interface name.

redistribute¶

Redistributes routes learned from other routing protocols.

vsr running config# vrf <vrf> routing ripng
vsr running ripng# redistribute <redistribute> metric <uint8> route-map ROUTE-MAP

`<redistribute>` values	Description
connected	Connected routes (directly attached subnet or host).
kernel	Kernel routes (not installed via the zebra RIB).
isis	Intermediate system to intermediate system (ISIS).
ospf6	Open Shortest Path First (OSPFv3).
bgp	Border Gateway Protocol (BGP).
static	Statically configured routes.

metric¶

Metric used for the redistributed route. If a metric is not specified, the metric configured with the default-metric attribute in RIPng router configuration is used. If the default-metric attribute has not been configured, the default metric for redistributed routes is 0.

metric <uint8>

route-map¶

Applies the conditions of the specified route-map to routes that are redistributed into the RIPng routing instance.

route-map ROUTE-MAP

ROUTE-MAP

Route map name.

timers¶

Settings of basic timers.

vsr running config# vrf <vrf> routing ripng timers

flush-interval¶

Interval before a route is flushed from the routing table.

vsr running config# vrf <vrf> routing ripng timers
vsr running timers# flush-interval <uint16>

Default value: 120

holddown-interval¶

Interval before better routes are released.

vsr running config# vrf <vrf> routing ripng timers
vsr running timers# holddown-interval <uint16>

Default value: 180

update-interval¶

Interval at which RIP updates are sent.

vsr running config# vrf <vrf> routing ripng timers
vsr running timers# update-interval <uint16>

Default value: 30

distribute-list¶

Filter networks in routing updates.

vsr running config# vrf <vrf> routing ripng
vsr running ripng# distribute-list <interface> <update-direction> access-list ACCESS-LIST \
... prefix-list PREFIX-LIST

`<interface>` values	Description
<ifname>	An interface name.
all	Match all interfaces.

`<update-direction>` values	Description
in	Incoming updates.
out	Outgoing updates.

access-list¶

Access-list name.

access-list ACCESS-LIST

ACCESS-LIST

Access list name.

prefix-list¶

Prefix-list name.

prefix-list PREFIX-LIST

PREFIX-LIST

Prefix list name.

offset-list¶

Offset-list to modify route metric.

vsr running config# vrf <vrf> routing ripng
vsr running ripng# offset-list <interface> <update-direction> metric <uint8> \
... access-list ACCESS-LIST

`<interface>` values	Description
<ifname>	An interface name.
all	Match all interfaces.

`<update-direction>` values	Description
in	Incoming updates.
out	Outgoing updates.

metric (mandatory)¶

Route metric.

metric <uint8>

access-list (mandatory)¶

Access-list name.

access-list ACCESS-LIST

ACCESS-LIST

Access list name.

state (state only)¶

Operational RIPng state data.

route (state only)¶

RIPng IPv6 route state.

protocol (state only)¶

Route protocol.

vsr> show state vrf <vrf> routing ripng state route <route> protocol

route-type (state only)¶

Route type.

vsr> show state vrf <vrf> routing ripng state route <route> route-type

nexthop (state only)¶

Nexthop IPv6 address.

vsr> show state vrf <vrf> routing ripng state route <route> nexthop

metric (state only)¶

Route metric.

vsr> show state vrf <vrf> routing ripng state route <route> metric

neighbor (state only)¶

RIP neighbor state.

last-update (state only)¶

The time when the most recent RIP update was received from this neighbor.

vsr> show state vrf <vrf> routing ripng state neighbor <neighbor> last-update

bad-packets-received (state only)¶

The number of RIP invalid packets received from this neighbor which were subsequently discarded for any reason (e.g. a version 0 packet, or an unknown command type).

vsr> show state vrf <vrf> routing ripng state neighbor <neighbor> bad-packets-received

bad-routes-received (state only)¶

The number of routes received from this neighbor, in valid RIP packets, which were ignored for any reason (e.g. unknown address family, or invalid metric).

vsr> show state vrf <vrf> routing ripng state neighbor <neighbor> bad-routes-received