3.1. User Guide - CLI / NETCONF

6WIND command line interface (CLI) is the user interface to interact with a device running 6WIND - Virtual Service Router. It can be used to configure, monitor and troubleshoot the router.

The CLI is a NETCONF client, following a data model described in YANG. The command names and statements follow the syntax and the hierarchical organization of the Virtual Service Router YANG models.

A NETCONF API can be used as well from any other NETCONF clients to configure and monitor the router remotely.

About NETCONF

NETCONF is a network management protocol standardized by the IETF. It defines mechanisms to install, manipulate and delete the configuration of network devices. It uses Extensible Markup Language (XML)-based data encoding for the configuration data as well as the protocol messages. More information is available in RFC 6241 at https://tools.ietf.org/html/rfc6241

About YANG

YANG is a language used to model data for the NETCONF protocol. A YANG module defines a hierarchy of data that can be used for NETCONF-based operations, including configuration, state data, Remote Procedure Calls (RPCs), and notifications for network management protocols. More information is available in RFC 7950 https://tools.ietf.org/html/rfc7950

This document is organized as follows:

• 3.1.1. Preface
• 3.1.2. Key features
• 3.1.3. Basics
• 3.1.4. System
• 3.1.5. Network interfaces
• 3.1.6. IP Networking
• 3.1.7. Routing
• 3.1.8. QoS
• 3.1.9. Security
• 3.1.10. High Availability
• 3.1.11. Monitoring
• 3.1.12. Services
• 3.1.13. Maximum Capacity Specifications
• 3.1.14. Troubleshooting
• 3.1.15. Automation