Identify A NIC Port¶

If you ever need to, you can have a specific port of a physical NIC on the router blink to visually identify it.

To do that, run the following command:

vsr> cmd identify-port pci-b131s0f1 duration 300

Where pci-b131s0 is the network-port you want to identify.

The command can be interrupted before the specified duration (in seconds) by hitting ctrl-c.

Note

If you see the following error message:

Cannot identify NIC: Operation not supported

It means that your network adapter does not support LED control.

Tip

To display the list of all network-ports and their description, you may use the following command:

vsr> show state / network-port
network-port pci-b6s0
    bus-addr 0000:06:00.0
    vendor "Intel Corporation"
    model "I350 Gigabit Network Connection"
    mac-address 52:54:00:12:34:57
    interface eth0
    ..
network-port pci-b131s0
    bus-addr 0000:83:00.0
    vendor "Intel Corporation"
    model "82599ES 10-Gigabit SFI/SFP+ Network Connection"
    mac-address de:ad:de:01:02:03
    interface eth1
    ..
network-port pci-b131s0f1
    bus-addr 0000:83:00.1
    vendor "Intel Corporation"
    model "82599ES 10-Gigabit SFI/SFP+ Network Connection"
    mac-address 52:54:00:12:34:56
    interface eth2
    ..
network-port pci-b134s0
    bus-addr 0000:86:00.0
    vendor "Mellanox Technologies"
    model "MT27700 Family [ConnectX-4]"
    mac-address 52:54:00:12:34:58
    interface eth3
    ..
network-port pci-b134s0f1
    bus-addr 0000:86:00.1
    vendor "Mellanox Technologies"
    model "MT27700 Family [ConnectX-4]"
    mac-address 52:54:00:12:34:59
    interface eth4
    ..