ripng¶
RIPng router configuration.
vrouter running config# vrf <vrf> routing ripng
aggregate¶
Set aggregate RIPng route announcement.
vrouter running config# vrf <vrf> routing ripng
vrouter running ripng# aggregate AGGREGATE
| AGGREGATE | An IPv6 prefix: address and CIDR mask. |
static-route¶
RIPng static routes.
vrouter running config# vrf <vrf> routing ripng
vrouter running ripng# static-route STATIC-ROUTE
| STATIC-ROUTE | An IPv6 prefix: address and CIDR mask. |
enabled¶
Enable or disable router.
vrouter running config# vrf <vrf> routing ripng
vrouter running ripng# enabled true|false
- Default value
true
allow-ecmp¶
Allow equal-cost multi-path.
vrouter running config# vrf <vrf> routing ripng
vrouter running ripng# allow-ecmp true|false
- Default value
false
default-information-originate¶
Control distribution of default route.
vrouter running config# vrf <vrf> routing ripng
vrouter running ripng# default-information-originate true|false
- Default value
false
default-metric¶
Default metric of redistributed routes.
vrouter running config# vrf <vrf> routing ripng
vrouter running ripng# default-metric <uint8>
- Default value
1
network¶
Enable RIP on the specified IP network.
vrouter running config# vrf <vrf> routing ripng
vrouter running ripng# network NETWORK
NETWORK values |
Description |
|---|---|
| <A.B.C.D/M> | An IPv4 prefix: address and CIDR mask. |
| <X:X::X:X/M> | An IPv6 prefix: address and CIDR mask. |
interface¶
Enable RIP on the specified interface.
vrouter running config# vrf <vrf> routing ripng
vrouter running ripng# interface INTERFACE
| INTERFACE | An interface name. |
passive-interface¶
A list of interfaces where the sending of RIP packets is disabled.
vrouter running config# vrf <vrf> routing ripng
vrouter running ripng# passive-interface PASSIVE-INTERFACE
| PASSIVE-INTERFACE | An interface name. |
redistribute¶
Redistributes routes learned from other routing protocols.
vrouter running config# vrf <vrf> routing ripng
vrouter running ripng# redistribute <redistribute> metric <uint8> route-map ROUTE-MAP
<redistribute> values |
Description |
|---|---|
| connected | Connected routes (directly attached subnet or host). |
| kernel | Kernel routes (not installed via the zebra RIB). |
| ospf6 | Open Shortest Path First (OSPFv3). |
| bgp | Border Gateway Protocol (BGP). |
| static | Statically configured routes. |
metric¶
Metric used for the redistributed route. If a metric is not specified, the metric configured with the default-metric attribute in RIPng router configuration is used. If the default-metric attribute has not been configured, the default metric for redistributed routes is 0.
metric <uint8>
route-map¶
Applies the conditions of the specified route-map to routes that are redistributed into the RIPng routing instance.
route-map ROUTE-MAP
| ROUTE-MAP | Route map name. |
protocol (state only)¶
Routing protocol.
vrouter> show state vrf <vrf> routing ripng redistribute <redistribute> protocol
timers¶
Settings of basic timers.
vrouter running config# vrf <vrf> routing ripng timers
flush-interval¶
Interval before a route is flushed from the routing table.
vrouter running config# vrf <vrf> routing ripng timers
vrouter running timers# flush-interval <uint16>
- Default value
120
holddown-interval¶
Interval before better routes are released.
vrouter running config# vrf <vrf> routing ripng timers
vrouter running timers# holddown-interval <uint16>
- Default value
180
update-interval¶
Interval at which RIP updates are sent.
vrouter running config# vrf <vrf> routing ripng timers
vrouter running timers# update-interval <uint16>
- Default value
30
distribute-list¶
Filter networks in routing updates.
vrouter running config# vrf <vrf> routing ripng
vrouter running ripng# distribute-list <interface> <update-direction> access-list ACCESS-LIST \
... prefix-list PREFIX-LIST
<interface> values |
Description |
|---|---|
| <ifname> | An interface name. |
| all | Match all interfaces. |
<update-direction> values |
Description |
|---|---|
| in | Incoming updates. |
| out | Outgoing updates. |
interface (state only)¶
Interface to match.
vrouter> show state vrf <vrf> routing ripng distribute-list <interface> <update-direction> interface
update-direction (state only)¶
Incoming or outgoing updates.
vrouter> show state vrf <vrf> routing ripng distribute-list <interface> <update-direction> update-direction
offset-list¶
Offset-list to modify route metric.
vrouter running config# vrf <vrf> routing ripng
vrouter running ripng# offset-list <interface> <update-direction> metric <uint8> \
... access-list ACCESS-LIST
<interface> values |
Description |
|---|---|
| <ifname> | An interface name. |
| all | Match all interfaces. |
<update-direction> values |
Description |
|---|---|
| in | Incoming updates. |
| out | Outgoing updates. |
interface (state only)¶
Interface to match.
vrouter> show state vrf <vrf> routing ripng offset-list <interface> <update-direction> interface
update-direction (state only)¶
Incoming or outgoing updates.
vrouter> show state vrf <vrf> routing ripng offset-list <interface> <update-direction> update-direction
state (state only)¶
Operational RIPng state data.
route (state only)¶
RIPng IPv6 route state.
protocol (state only)¶
Route protocol.
vrouter> show state vrf <vrf> routing ripng state route <route> protocol
route-type (state only)¶
Route type.
vrouter> show state vrf <vrf> routing ripng state route <route> route-type
nexthop (state only)¶
Nexthop IPv6 address.
vrouter> show state vrf <vrf> routing ripng state route <route> nexthop
metric (state only)¶
Route metric.
vrouter> show state vrf <vrf> routing ripng state route <route> metric
neighbor (state only)¶
RIP neighbor state.
last-update (state only)¶
The time when the most recent RIP update was received from this neighbor.
vrouter> show state vrf <vrf> routing ripng state neighbor <neighbor> last-update
bad-packets-received (state only)¶
The number of RIP invalid packets received from this neighbor which were subsequently discarded for any reason (e.g. a version 0 packet, or an unknown command type).
vrouter> show state vrf <vrf> routing ripng state neighbor <neighbor> bad-packets-received
bad-routes-received (state only)¶
The number of routes received from this neighbor, in valid RIP packets, which were ignored for any reason (e.g. unknown address family, or invalid metric).
vrouter> show state vrf <vrf> routing ripng state neighbor <neighbor> bad-routes-received